Barnacle_Gil Posted August 15, 2021 Share Posted August 15, 2021 Do you trust your thermometer? I don't! I suspected something was off when I setup my quarantine tank (5 gal.) with a new heater and a floating thermometer and nothing was even close to lining up temp. wise. I set the heater for 78 degrees and the thermometer registered 84 degrees! What the heck! The heater manufacturer claims an accuracy of +- 2deg. so I had 3 old glass floaters left in a box from back in the day and I dropped them in the tank too. So now I was getting readings from 70-84 across 4 different floaters! Nothing was matching up! I had purchased one of those fancy stick on black digital thingies (I hate those things, you gotta use a flashlight to see them) and stuck that on too. That one actually agreed with the heater! Go figure! I've ordered a new floater here from the Co-op and hope it's a good one. So I guess the point here is do you trust your thermometer? How do you verify the temp? It goes without saying how important this is. Any suggestions or recommendations? Temp gun? I'm just getting back into the hobby and I don't want to start out by cooking anything. Thanks for any help. Link to comment Share on other sites More sharing options...
Brymac1 Posted August 15, 2021 Share Posted August 15, 2021 I use an Inkbird heater controller that has two temperature probes to make sure my tank is at the right temperature. It will also shut off the heaters if they get stuck on. 4 Link to comment Share on other sites More sharing options...
Hoi Polloi Posted August 15, 2021 Share Posted August 15, 2021 A decent cooking thermometer plus a decent tank thermometer. Most thermometers have a +-2 degree variance. Quality is hard to find. 1 Link to comment Share on other sites More sharing options...
quikv6 Posted August 15, 2021 Share Posted August 15, 2021 To be honest, I trust a thermometer more than I do the heater dial. I've had multiple heaters of the same style that were off quite a bit. I use the black digital thermometer AND a glass one. It's good to have checks and balances. 4 Link to comment Share on other sites More sharing options...
Guppysnail Posted August 15, 2021 Share Posted August 15, 2021 (edited) On 8/15/2021 at 2:15 PM, Brymac1 said: I use an Inkbird heater controller that has two temperature probes to make sure my tank is at the right temperature. It will also shut off the heaters if they get stuck on. I use these in all my tanks. I use the non WiFi single probe dual plug ones they are cheap and reliable. I don’t trust therm or heater dial. I calibrate the inkbird to a temp laser gun. They are super simple to operate and calibrate. I had to many heaters poach fish as you said in your intro…ahh the good old days….not 🤣 Edited August 15, 2021 by Guppysnail 1 Link to comment Share on other sites More sharing options...
GameCzar Posted August 15, 2021 Share Posted August 15, 2021 On 8/15/2021 at 1:56 PM, quikv6 said: To be honest, I trust a thermometer more than I do the heater dial. I've had multiple heaters of the same style that were off quite a bit. I use the black digital thermometer AND a glass one. It's good to have checks and balances. Definitely. I've never owned one that was exact. Usually I have to keep them a couple of degrees lower. I have a IR thermometer I use, and I have a couple of digitals in a few tanks. 3 Link to comment Share on other sites More sharing options...
Daniel Posted August 15, 2021 Share Posted August 15, 2021 You can get a NIST traceable thermometer that accurate to +/- 0.1 F and use it to calibrate your other thermometers. Here is the one I use: Once the thermometers are calibrated they hold calibration pretty well. Here are 3 calibrated temperature probes all in the same buffer solution at the same time giving close to the same reading: But the thermometer I use most often is my hand. If the water luke/cool it is low 70s F. If the water is lukewarm, it is middle 70s F, is the water is warmish it is about 80 and if the water is warm it is upper 80s. 3 1 Link to comment Share on other sites More sharing options...
Ken Posted August 15, 2021 Share Posted August 15, 2021 I use one of these. I assume it's accurate (it agrees with my in tank thermometers). The picture shows shooting the glass but I usually hit the water directly. It's also great for cooking and just all 'round playing with. It's an ETEKCITY from Amazon about $27. 2 Link to comment Share on other sites More sharing options...
Streetwise Posted August 15, 2021 Share Posted August 15, 2021 @Daniel, do you have a link? I would love to calibrate. Link to comment Share on other sites More sharing options...
Daniel Posted August 15, 2021 Share Posted August 15, 2021 On 8/15/2021 at 4:48 PM, Streetwise said: @Daniel, do you have a link? I would love to calibrate. This one is very similar to the one I use. 1 Link to comment Share on other sites More sharing options...
CalmedByFish Posted August 15, 2021 Share Posted August 15, 2021 I bought about a dozen of the glass floating thermometers, then lined them all up in the middle of a large tank. Several had the same temp, which was near the middle of the other temps. I took them out and put them in separate tanks, with a post-it note on the black rim by it that said "within 1 degree." The others got put in labeled ziplocs to use if needed. The labels are things like "real temp is below this thermometer." 3 Link to comment Share on other sites More sharing options...
Streetwise Posted August 15, 2021 Share Posted August 15, 2021 @CalmedByFish, have you tested an Apex thermometer or pH meter? 1 Link to comment Share on other sites More sharing options...
CT_ Posted August 15, 2021 Share Posted August 15, 2021 I calibrate against a 15$ catheter thermistor. Since it's a medical device it is very accurate near body temperature but you need a multimeter and a lookup take to use it. Turns out my digital meat thermometer happens to be spot on. A LOT of ice with distilled water will also be very very close to 0 C as that's an intrinsic temperature standard. But I have thermometers that read spot on at 0 but are pretty off at tank temps. I assume they get factory calibrated with ice water but don't have a calibration point near tank temperature Link to comment Share on other sites More sharing options...
Streetwise Posted August 15, 2021 Share Posted August 15, 2021 I have enjoyed collecting Apex Temperature and pH data to learn how my tanks change with lighting and other conditions. 1 Link to comment Share on other sites More sharing options...
sairving Posted August 15, 2021 Share Posted August 15, 2021 (edited) I have a floating thermometer in my tank. I used the thermometer I have for making tea to check the tank temperature one day. The floating thermometer was accurate. Probably just lucked out that its accurate. Edited August 15, 2021 by Stephanie I 1 Link to comment Share on other sites More sharing options...
Scott P. Posted August 15, 2021 Share Posted August 15, 2021 I use a laser temp gun. Comes in real handy in the kitchen also. Those little $! glass thermometers are junk and impossible to read. Link to comment Share on other sites More sharing options...
Gator Posted August 16, 2021 Share Posted August 16, 2021 I use a digital thermometer I picked up at a LFS that came with an extra battery, I used a digital meat thermometer to confirm accuracy, it was so accurate I bought three more, they're just as accurate, and I am so happy. Those glass tube thermometers get jostled around so much in transportation that the pasteboard gauge gets jostled out of position, maybe by a little, maybe by a lot. You should consider raising the temps in your tanks to about 85 degrees to prevent diseases. Link to comment Share on other sites More sharing options...
Hobbit Posted August 16, 2021 Share Posted August 16, 2021 On 8/15/2021 at 6:23 PM, Stephanie I said: I used the thermometer I have for making tea to check the tank temperature one day. I use a tea thermometer when I’m doing water changes. It’s fast and seems accurate! Otherwise I use the floating ones. Which are hopefully accurate. Though I’ve never tested them… @Daniel I wish I could judge it by feel but I’ve learned that for me, how the water feels depends a LOT on the temp in the house and how exothermic I am. The same temp water can feel really cold in the summer but nice and warm in the winter. 2 Link to comment Share on other sites More sharing options...
sairving Posted August 16, 2021 Share Posted August 16, 2021 On 8/15/2021 at 7:43 PM, Hobbit said: I use a tea thermometer when I’m doing water changes. It’s fast and seems accurate! Otherwise I use the floating ones. Which are hopefully accurate. Though I’ve never tested them… @Daniel I don't think I've ever actually calibrated the thermometer I use for making tea. Although it can't be too far off because my tea tastes good after brewing (most of the time). 😃 1 Link to comment Share on other sites More sharing options...
Odd Duck Posted August 16, 2021 Share Posted August 16, 2021 I always compare a new therm to at least one old one that I trust, no matter what type. Plus I check with a hand against the glass or in the water depending on what’s going on that day. Like @Daniel I know that slightly cool is low 70’s for shrimp, plant, and blackworm culture tanks, neutral/lukewarm to touch for my community and puffer tanks at mid-ish 70’s, and slightly warm for Betta tank at high 70’s to 80. 1 Link to comment Share on other sites More sharing options...
CalmedByFish Posted August 16, 2021 Share Posted August 16, 2021 On 8/15/2021 at 4:05 PM, Streetwise said: @CalmedByFish, have you tested an Apex thermometer or pH meter? I don't even remember hearing about those until this thread... nor a tea thermometer. On 8/15/2021 at 8:16 PM, Odd Duck said: I check with a hand against the glass or in the water depending on what’s going on that day. Like @Daniel I know that slightly cool is low 70’s for shrimp, plant, and blackworm culture tanks, neutral/lukewarm to touch for my community and puffer tanks at mid-ish 70’s, and slightly warm for Betta tank at high 70’s to 80. I should learn this little trick! It seems so obvious, now that I hear it. I make a point of keeping adaptable species, so I don't really need perfection. 1 Link to comment Share on other sites More sharing options...
BenA Posted August 17, 2021 Share Posted August 17, 2021 On 8/15/2021 at 9:42 PM, Daniel said: But the thermometer I use most often is my hand. If the water luke/cool it is low 70s F. If the water is lukewarm, it is middle 70s F, is the water is warmish it is about 80 and if the water is warm it is upper 80s. It is the same principal as my Stone Weather Centre, very accurate and 100% reliable: If the stone is wet ; It is raining. If the stone is dry; It is not raining. If the stone is white; It is icy or snowing. If the stone has gone; there is Hurricane. 😉 6 Link to comment Share on other sites More sharing options...
Barnacle_Gil Posted August 18, 2021 Author Share Posted August 18, 2021 Haven't been able to post since my Xfinity has been down for the past 3 days due to the storms up here in MI. Thanks for all the responses here. I ordered the "ETEKCITY 774" from Amazon for $23 in the mean time and I'm really impressed with it. It turns out that only one of the floaters and the digital sticky thing matches the temp gun. So my two tanks are at 79.5 deg. and that's with the heaters NOT coming on. I think a degree or two cooler would be better but we don't keep the air conditioning running all summer. Thanks everybody ...... I'm gonna go make some tea now 😉 1 Link to comment Share on other sites More sharing options...
Gideyon Posted August 18, 2021 Share Posted August 18, 2021 (edited) I always assumed the glass ones would be the most trustworthy. I guess I was wrong based on what people are saying here. And I never knew people checked the temperature of their tea. Edited August 18, 2021 by Gideyon Link to comment Share on other sites More sharing options...
gardenman Posted August 18, 2021 Share Posted August 18, 2021 I have an Etekcity infrared thermometer that I use for everything. (The red laser dot makes a neat cat toy and can also be used to annoy the fish who think it's food and chase it around the tank.) I also have an instant read digital probe thermometer that's used for cooking and they both agree on temps. If you're shopping for a conventional glass tube type thermometer in stores, be sure to compare the readings on all of them. You'll find a general agreement on most with some varying wildly one direction or the other. Quality contorl for thermometers is not great. 2 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now