dan94 Posted September 8, 2021 Share Posted September 8, 2021 Hello all! I am in a quest to bring my KH just a few degrees in my new tank as I am injecting C02 and want a little more buffering capacity. I purchased Aquavitro Carbonate product, which is a liquid additive that increases KH. While this works, the way the dosing works out I will go through quite a lot of it. Has anyone else tried this product? What are some other options you have had luck with? I know many use crushed coral, but I have wondered if I have the space in my filter to fit it along with my other media. Thanks in advance! 1 Link to comment Share on other sites More sharing options...
Fish Folk Posted September 8, 2021 Share Posted September 8, 2021 On 9/7/2021 at 11:22 PM, dan94 said: Hello all! I am in a quest to bring my KH just a few degrees in my new tank as I am injecting C02 and want a little more buffering capacity. I purchased Aquavitro Carbonate product, which is a liquid additive that increases KH. While this works, the way the dosing works out I will go through quite a lot of it. Has anyone else tried this product? What are some other options you have had luck with? I know many use crushed coral, but I have wondered if I have the space in my filter to fit it along with my other media. Thanks in advance! I use crushed coral. Sometimes I just dump it unceremoniously on top of the substrate. On other occasions I hide and camouflage a black mesh bag of it in the Hardscape. One thing I’ve found is that CO2 tends to wear down buffer, and poise tanks for pH crash. I’m not sure if Crushed Coral would release at the rate that CO2 breaks down or not. I assume you know this… but for new explorers with CO2, never dose at lights out, since plants can only utilize it during photosynthesis. 1 Link to comment Share on other sites More sharing options...
gardenman Posted September 8, 2021 Share Posted September 8, 2021 My tap water has essentially no KH out of the tap so I use aragonite either mixed into the gravel or in my canister filters and it does a great job. 1 Link to comment Share on other sites More sharing options...
Mmiller2001 Posted September 8, 2021 Share Posted September 8, 2021 Use potassium carbonate, it's dirt cheap on Amazon and can be measured easily. CellarScience - AD640LB Potassium Carbonate (lb) https://www.amazon.com/dp/B074D9BXRT/ref=cm_sw_r_apan_glt_fabc_VS7F33QF3X69SK8M4X9J 2 Link to comment Share on other sites More sharing options...
dan94 Posted September 8, 2021 Author Share Posted September 8, 2021 On 9/8/2021 at 11:28 AM, Mmiller2001 said: Use potassium carbonate, it's dirt cheap on Amazon and can be measured easily. CellarScience - AD640LB Potassium Carbonate (lb) https://www.amazon.com/dp/B074D9BXRT/ref=cm_sw_r_apan_glt_fabc_VS7F33QF3X69SK8M4X9J Thats the main ingredient in this Carbonate product I purchased. When I run out of this I will look into that, thank you! Link to comment Share on other sites More sharing options...
dan94 Posted September 8, 2021 Author Share Posted September 8, 2021 On 9/8/2021 at 8:20 AM, Fish Folk said: I use crushed coral. Sometimes I just dump it unceremoniously on top of the substrate. On other occasions I hide and camouflage a black mesh bag of it in the Hardscape. One thing I’ve found is that CO2 tends to wear down buffer, and poise tanks for pH crash. I’m not sure if Crushed Coral would release at the rate that CO2 breaks down or not. I assume you know this… but for new explorers with CO2, never dose at lights out, since plants can only utilize it during photosynthesis. Ahh thats a good idea. I havent wanted to put it on top of my substrate, but I could probably find somewhere in the tank to hide a bag, especially as my plants continue to grow in. Thanks! 1 Link to comment Share on other sites More sharing options...
dan94 Posted September 8, 2021 Author Share Posted September 8, 2021 Anyone here tried out Seachem Alkaline Buffer? Link to comment Share on other sites More sharing options...
Mmiller2001 Posted September 8, 2021 Share Posted September 8, 2021 On 9/8/2021 at 10:12 AM, dan94 said: Anyone here tried out Seachem Alkaline Buffer? I have, potassium carbonate is easier to measure and is just potassium carbonate versus a proprietary mixture. 1 Link to comment Share on other sites More sharing options...
Administrators Zenzo Posted September 8, 2021 Administrators Share Posted September 8, 2021 You can put a bag (or a nylon stocking) with some crushed coral inside of a filter, or hide it behind a rock, plant, or piece of wood. You can then add a buffer (either your own recipe or a pre-made option). Link to comment Share on other sites More sharing options...
Jeeperscreepersmyth Posted September 8, 2021 Share Posted September 8, 2021 I use those cuddlefish wonderbones that are ground up and reconstituted since i need tons of calcium for my shrimp and snails and before i started using it i think my kh was around 8 now its at 13. May be many better options our there but thats just my personal experience. Link to comment Share on other sites More sharing options...
Mmiller2001 Posted September 8, 2021 Share Posted September 8, 2021 Using crushed coral or cuttlebone would be a mistake. Both of those raise GH. Link to comment Share on other sites More sharing options...
Grant Posted September 9, 2021 Share Posted September 9, 2021 I've used Seachem Alkaline Buffer. Pretty straightforward stuff. I use it without their acid buffer. I would take a guess that its a blend of potassium and magnesium carbonate. the majority of Alkaline buffer looks like pearl ash (potassium carbonate) and it has a very dusty residue to it as well that reminds me of magnesium carbonate. Perhaps there is some calcium carbonate, but I would think that would leave an insoluble residue - especially as pH increases and temperature decreases. I may be wayyyy off in my analysis, and i really wish they published a chemical survey. it may just be an overpriced container of potassium carb lol. My plants respond to it as if it were a fertilizer. it does require redosing as i've caught my pH drops over time in my low tech setup. I've also noticed that it will lower my gH as well for some reason. either the plants are using it up, or there is something chemical going on. My ramshorn snails respond pretty well to it. their shells grow out much more glossy and smooth since i started dosing it. my tapwater is already fairly hard, but lacks a lot of kH. that's why i supply it. (Tulsa,OK) Baking Soda will slap your Kh up very quickly, but then you're adding a marginal amount of sodium. There can be contaminants in the soda unless it is aquarium/food specific. the soda in the baking aisle is probably the cleanest option for the price. The reef guys will use lab-grade baking soda in some instances. 1 Link to comment Share on other sites More sharing options...
dan94 Posted September 9, 2021 Author Share Posted September 9, 2021 On 9/9/2021 at 12:12 AM, Grant said: I've used Seachem Alkaline Buffer. Pretty straightforward stuff. I use it without their acid buffer. I would take a guess that its a blend of potassium and magnesium carbonate. the majority of Alkaline buffer looks like pearl ash (potassium carbonate) and it has a very dusty residue to it as well that reminds me of magnesium carbonate. Perhaps there is some calcium carbonate, but I would think that would leave an insoluble residue - especially as pH increases and temperature decreases. I may be wayyyy off in my analysis, and i really wish they published a chemical survey. it may just be an overpriced container of potassium carb lol. My plants respond to it as if it were a fertilizer. it does require redosing as i've caught my pH drops over time in my low tech setup. I've also noticed that it will lower my gH as well for some reason. either the plants are using it up, or there is something chemical going on. My ramshorn snails respond pretty well to it. their shells grow out much more glossy and smooth since i started dosing it. my tapwater is already fairly hard, but lacks a lot of kH. that's why i supply it. (Tulsa,OK) Baking Soda will slap your Kh up very quickly, but then you're adding a marginal amount of sodium. There can be contaminants in the soda unless it is aquarium/food specific. the soda in the baking aisle is probably the cleanest option for the price. The reef guys will use lab-grade baking soda in some instances. Thanks for the info! I bought some Alkaline Buffer at my LFS today to give a shot. Just trying to get it under control before I put any livestock in my new tank. Being my first C02 build, I want to be careful to not have any major PH swings. How often do you need to redose to keep your KH at your desired level? Link to comment Share on other sites More sharing options...
lefty o Posted September 9, 2021 Share Posted September 9, 2021 im in the crushed coral camp. a handful or two mixed in the substrate on the smaller tanks, maybe a pound in the large tank. like about everything i dont use near the recommended amount, but it works for my needs. Link to comment Share on other sites More sharing options...
Grant Posted September 9, 2021 Share Posted September 9, 2021 On 9/8/2021 at 11:31 PM, dan94 said: Thanks for the info! I bought some Alkaline Buffer at my LFS today to give a shot. Just trying to get it under control before I put any livestock in my new tank. Being my first C02 build, I want to be careful to not have any major PH swings. How often do you need to redose to keep your KH at your desired level? My test strips tell me it's 120ppm/6.7dKH/2.39meql this floats me between 6.0-7.0 pH. I end up dosing once a week or biweekly. I also add about half the recommended dose and that seems to be sufficient in my system. If you plan on pushing 30ppm of CO2, then you will probably need to dose more frequently/intensely. if you plan on keeping the CO2 at a lower level, then less buffer may be necessary depending on your goals. adding some crushed coral could give you a little extra buffer in case you miss a dose or life happens. lower doses of CO2 should also afford you more wiggle room in regard to buffer dosing and life events. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now