Search the Community
Showing results for tags 'drip water change'.
Found 2 results
-
Hello everyone, So i've essentially got an infinite amount of H2O at my disposal now that i've automated all my water changes using carbon block water filters and overflows. I'm wondering wether there's a limit for how much you can change the water before it will affect the bacteria or fish? Is 200% a week overkill when you're heavily feeding and the water being changed "gradually throughout the week" is pretreated, heated and oxygenated etc? I want to be able to over feed bucket loads of brine shrimp and not worry about clouding or ammonia spikes by doing 20-30% water changes on a drip system throughout the day. In an ideal world i'd have a drip system to feed live brine shrimp every 2 hours as-well but that's a problem for some other high-tech automation Nerm to work out 😅 I've successfully drilled all 20 of my Grow Out and Conditioning Tanks with 1/4 inch holes for attaching quick connect pipes and irrigation tube for draining water. Now drilling a few more for auto water top-offs and extra drainage on bigger tanks "it's painfully slow but doesn't really need to be much wider pipe with a drip system". Everything seems to be going smooth so far, for now i'm manually topping off the tanks every other day and they drain themselves to about an inch or two from the rim of the tank. 🤞🏻😅 I've also discovered adding a length of tube to an elbow or T-Fitting will bell siphon the tank to as low as you want and then you can fill to just under the outlet hole until you're ready to do another water change, top it off and let it siphon back down again! 😄 I use tap water filtered with carbon then catalytic carbon blocks (which filters out the chlorine + chloramines that I've discovered Melbourne Water has a small amount of in Australia) Now the plan is to set up a water pump on a solenoid to automatically fill the tanks each day through the inlet hole with a couple gallons of treated water from a big water drum hidden upstairs in the pantry haha (and auto dosing a dash of prime into the drum every other day to combat the excess ammonia that is generated when you filter out chloramines with carbon) Or perhaps I could be using Purigen or some other ammonia sucking resin for that 🤔 The third hole is going to be plugged or just extra drainage for now, but at some point I might use it for mixing RO water into specific tanks with fish that like super soft water or to trick Corydoras into breeding i've heard haha 🤣 Perhaps it can be my Brine Shrimp Dispensing Inlet when someone invents a live Brine Shrimp Generator hahaha- 2 replies
-
- 1
-
-
- water changes
- auto waterchange
- (and 9 more)
-
I just installed a line for doing drip auto water changes into a short rack of tanks. Because I'm familiar with the DripWorks stuff for gardening, I ran a line above the tanks and tapped in some drippers. I'm realizing now, this isn't the world's best solution for my application. Where the driplines tap into the mainline isn't the tightest fit and each line occasionally drips at its tap point a teeeeeeny tiny bit. Nothing dramatic, but a drip nonetheless. So, the question . . . for those who've set up similar systems, how do you do it? 1/4 RO tubing and john guest fittings? Something something else? I only have a short run of the drip system above the tanks, so plumbing up an alternative solution wouldn't be that time consuming. Just looking for the advice and experience of other's who've successfully done this.
