mellowouttt

So @Buckman- I think I found the issue. Shitty safety valve -_- I hope I didn't damage the diffuser too much -_-

Yeah - it is interesting. The PSI on the outlet is actually decently high. The Diffuser is not letting air through. When I test - it actually comes out of the line a bit. You can see the bubbles. But its not nearly enough to do that. Maybe their is an issue somewhere in the line. I will redo the entire line tomorrow 😕

Thanks for the response! I have a 22G Long - so the diffuser is about 10" under water. The Co2 Source is a 5lb pressurized system with regulator. I have been testing in a shallow cup - and nothing will come out of the diffuser. My other diffuser was just fine - however, the bubbles were not as fine as these. I am actively soaking the diffuser in bleach - and testing every hour. I will keep you posted if I have success. Everything I have found online says a bleach soak is the solution 😕 but 3 hours in - and no success so far. Edit: The diffuser worked very shortly within the bleach solution - and then quit working again. That is how I know the bubbles are much more fine then my previous diffuser - and why I am so steadfast on making this work 😛

Recently purchased the Co2 Diffuser from Aquarium Co-Op's website. Unfortunately, the bubles do not come out of the diffuser. The Co2 is coming out of the lining instead. This is not an issue with my other diffusers. Note: I do have Co2 lining. Is there a way to seal the tubing where it connects to the diffuser? I ruined my last one trying to super-glue it tight, and had to buy a 2nd -_-